If your ART-2000 or ART-2100 screen is blank, only showing half a screen, sending you FAIL messages, or creating a noise/vibration when getting powered down, you may not be following proper shutdown procedures.
In accordance with Service Aids for both ART-2000 and ART-2100, the following steps need to be followed to prevent these squawks.
When shutting down the radar system:
If the antenna does not have time to move to the center parked position, some noise and/or vibration may be noticeable when the system is turned off.
Failure to pause in the STANDBY position when turning the system off may cause the above stated squawks if the system is rapidly turned back on.
Important Information About Your Gogo Wi-Fi System
Do Not Delay. Your Honeywell MCDUs Are Facing Impending Component Obsolescence.
5 Reasons to Install A 5G Radio Altimeter Filter
Troubleshooting Lack Of Transmission Issues In Hawker 800XP HF System
It Is Easy To Avoid This Costly King Air Brake Fluid Reservoir Mistake